Burst Pipe Repair in Missoula, MT
Close the main water valve first, then call us and a licensed plumber who works in Missoula can stop by to repair the split pipe.
Stop the water in the first five minutesLicensed plumbers who work in Missoula

Stop the water in the first five minutes
Burst pipe repair in Missoula starts before the plumber arrives. Your first few moves decide how much floor, ceiling and wall ends up soaked.
Close the main water valve
Look where the supply line comes through the foundation, which in most homes is the street side of the basement or crawl space. Spin a wheel handle clockwise to its stop, or swing a lever ninety degrees so it lies crosswise.
Open a tap on the lowest floor
The water left in the lines then runs out there instead of through the split.
Make the room safe
If water is creeping toward outlets, a power strip or the panel, shut off that part of the house at the breaker while you stand on dry ground. If the panel sits in water, stay out and call.
Move what you can and call us
Lift rugs, boxes and electronics off the floor. Then call and describe where the pipe is and what it is made of, if you can see it.
Main valve missing or frozen in place? Our guide to shutting off your water fast lists other places to try.
Why pipes burst in Missoula homes
Most burst pipes in Missoula are a winter problem. When water freezes inside a pipe it expands, and the pressure between the ice plug and a closed tap has nowhere to go. The pipe splits at its weakest point, which is often a foot or two from the ice itself.
That is why many people discover a burst pipe on the first mild afternoon after a cold snap. While the water was frozen, the split stayed sealed. Once it thaws, water pours out at full pressure.
Cold is the most common reason for burst pipe repair in Missoula, but it is not the only one. Old galvanized steel pipe rusts from the inside, copper can wear thin where water turns sharp corners, and a fitting that was never tightened properly can give way years later. High water pressure makes every one of these more likely.
Where burst pipes usually hide
A plumber starts by looking at the places where pipes meet cold air, because that is where most splits happen.
Outside walls
Supply lines to kitchen and bathroom sinks often run inside exterior walls, with only a few inches of insulation between the pipe and the cold.
Crawl spaces and unheated basements
Pipes along the rim joist sit right beside the foundation, and drafts through gaps around the sill plate can freeze them quickly.
Garages and outside faucets
A hose still attached in winter holds water inside the faucet, and the pipe behind the siding can split while the faucet looks untouched.

Water still coming through the ceiling?
Close the main valve, keep clear of wet outlets and call about burst pipe repair in Missoula. A licensed Missoula plumber can visit to find the split.
When a burst pipe cannot wait, and when it can
Every burst pipe needs a repair, but not every one needs a plumber within the hour. These lists help you decide how quickly to call.
Call right away
- Water is spraying or pouring and you cannot find or close the main valve
- Water is coming through a ceiling or running near electrical outlets or the panel
- The whole house has no water during a hard freeze
- Water is running into a finished basement, under flooring or into a wall cavity
Can wait a few hours
- The main valve is closed and the leak has stopped
- A small drip from an outside faucet has stopped after you closed its shutoff
- The split pipe has its own valve, which you have closed, so other taps still work
- You can see the damaged section and the area around it is dry
Even when the water has stopped, the pipe around the split may be weak or frozen further along. Do not turn the main valve back on until the damaged section has been replaced.
How a plumber repairs a burst pipe
The plumber first confirms the water is off and finds the full length of damage. A split can be longer than it looks, and a pipe that froze in one spot may have bulged in another.
The plumber removes the split length and fits new pipe and fittings that match or improve on the old material. Copper, PEX and older galvanized lines each need different fittings, so knowing what you have helps the plumber bring the right parts.
With the new length in place, the plumber brings the water back gradually and checks each joint under full pressure. If the pipe froze, the plumber also looks at why, such as a gap in the insulation, a draft from outside or a hose that was left connected.
- Find and expose the damaged section
- Cut out the split and any bulged pipe
- Fit new pipe and fittings
- Restore pressure slowly and check every joint
- Point out what let the pipe freeze, so it does not happen again
Pipe materials found in Missoula homes
Houses here were built across many decades, so one home can have more than one kind of pipe. This is how each one tends to fail.
| Pipe | Where you see it | How it tends to fail |
|---|---|---|
| Copper | Supply lines in many homes, often in basements and walls | Splits when frozen, and can wear thin at elbows over many years |
| PEX | Flexible plastic supply lines in newer homes and repairs | Handles freezing better than copper, but fittings can still crack |
| Galvanized steel | Older homes that have not been fully repiped | Rusts from the inside, narrows over time and leaks at threaded joints |
| CPVC | Rigid cream colored plastic in some homes | Turns brittle over the years and may crack in a freeze |
Getting the room dry once the pipe is fixed
Once the burst pipe repair is finished, the next job is getting everything dry. Soak up standing water, open cabinets and closets near the leak, and run fans and a dehumidifier if you have them. In a heated house in winter, air dries surfaces quickly but water trapped under flooring or inside walls can stay wet for days.
Take photos of the damage and the repaired pipe before you clean up. If you plan to contact your insurance company, they will usually want to see where the water came from.
If a lot of water reached drywall, insulation or a finished basement, a water damage restoration company can measure the moisture and dry the house properly. The plumber can tell you whether the amount of water makes that worthwhile.
Keeping a repaired pipe from bursting again
The new section is only as safe as the spot it runs through. If cold reached it once, it will again, so the plumber will tell you what let the freeze in. Insulation, sealing drafts and outside faucets are all covered in the freeze prevention guide.
Repairing a split pipe inside a finished wall
When the split sits behind drywall or tile, the plumber opens only as much as the repair needs, usually a small panel beside the damaged run. That keeps the patching work afterwards as small as possible.
Before the wall is closed, the new section is tested under full pressure and the cavity is checked for trapped water, because a wet wall that is sealed up will grow mold.
- Open a small access panel at the split
- Replace the damaged run
- Test under full pressure
- Make sure the wall cavity has dried out before sealing it
Details that help on a burst pipe call
A few details help the plumber understand the job before arriving and bring the right fittings.
Whether the water is off
Tell us if you closed the main valve or a fixture valve, and whether the leak has stopped.
Where the pipe is
Basement ceiling, crawl space, inside a wall, under a sink or behind an outside faucet.
What it is made of
Copper is shiny or brown metal, PEX is flexible plastic in red, blue or white, and galvanized steel is dull gray with threaded joints.
What is wet
Whether water reached ceilings, flooring, electrical outlets or a finished room below.
Checking the rest of the house after a burst pipe
When one pipe bursts in a cold snap, others nearby may have frozen too. Once the repair is done and the water is back on, walk through the house and run each faucet, hot and cold, for a minute.
Look for weak flow at a fixture that used to run well, drips under sinks and damp spots on ceilings below bathrooms. Check outside faucets and the pipes in the garage as well.
Keep an eye on the water meter for the next day or two. If it moves while nothing is running, there may be a second leak that has not shown itself yet, and our page on leak detection explains how to track it down.
Burst pipe questions from Missoula homeowners
- How do I know if a pipe has burst behind a wall?
- Should I turn the water back on after the leak stops?
- Can I tape or clamp a burst pipe myself?
- Why did my pipe burst when the weather warmed up?
- Do burst pipes only happen in winter?
- What is step one when a pipe splits?
- Can a burst pipe cause mold?
- Will homeowners insurance pay for a burst pipe?
- Can a burst pipe be fixed without opening the wall?
How do I know if a pipe has burst behind a wall?
Listen for running water when every tap is off, watch the water meter for movement, and look for wet patches, bubbling paint or a stain spreading on drywall or a ceiling. A sudden drop in water pressure is another clue.
Should I turn the water back on after the leak stops?
No. Leave the main valve closed until the damaged section has been replaced. Turning it back on sends full pressure to the split, and the pipe on either side of it may be cracked as well.
Can I tape or clamp a burst pipe myself?
A clamp or repair tape may slow a small split for a few hours, but it is not a lasting fix. The split section still needs to be cut out and replaced.
Why did my pipe burst when the weather warmed up?
The ice inside the pipe was holding back the water. When it melted, water reached the split at full pressure. The damage happened during the freeze, but the leak only showed after the thaw.
Do burst pipes only happen in winter?
No. Freezing causes most of them in Missoula, but corroded pipe, worn fittings and very high water pressure can make a pipe fail at any time of year.
What is step one when a pipe splits?
Close the main valve, have the breakers off for any soaked room, get belongings out of harm and phone us.
Can a burst pipe cause mold?
It can if water sits in walls, insulation or flooring. Getting everything dry soon after the repair is the best defense.
Will homeowners insurance pay for a burst pipe?
That depends on your policy and how the pipe failed. Take photos of the damage and the repaired pipe and ask your insurance company. The plumber can describe what caused the split.
Can a burst pipe be fixed without opening the wall?
Sometimes, if the split is in an exposed pipe in a basement or crawl space. When it is inside a finished wall, a small opening at the damaged spot is usually needed.
More frozen and burst pipes help
- Frozen pipe repairNo water at a tap on a cold morning.
- Water line repairThe pipe between the street and your house.
Burst pipe repair in Missoula
Close the main water valve and call. One of the licensed plumbers working in Missoula can head over to replace the split section.